This is a sheet of custom decals made specifically for McFarlane Super Powers Figures. They are UV printed so they are slightly raised.

See the picture for what comes in this set. I’ve included duplicates of some in case of user error when applying them. I’ve also included a picture showing which figure each decal is for.

Since these take awhile to print and I have to fulfill numerous order, please allow 2 weeks for delivery, especially if you order during the first few days of the initial product launch.

Application instructions:

• Trim the sticker: Cut closely around your design with scissors or a paper trimmer, leaving minimal excess laminate edge.

• Peel the backing: Peel away the backing sheet to expose the sticky side of the transfer.

• Stick and burnish: Hold thetransfer in a U-shape, place the center down first, and roll it onto the surface. Rub firmly across the design using your thumb. Tip: when applying the decal, use a tweezers to hold it for more exact placement.

• Remove top layer: Wait 30 to 60 seconds, then slowly peel away the top film at a low angle to leave only the decal on your item.

• Application error: if applied incorrectly (e.g. crooked, off-center, etc) the decals can be gently scraped off.

DISCLAIMER: These are UV printed and can be scratched or chipped once applied. Handle with care. This store is not liable for any damage or user errors that may occur when applying (or removing) the decals to your figures. These are meant for customizers and collectors and not intended for children under 12.

International shipping is a flat fee. A partial refund will be given once actual shipping is calculated.